Đường link đã được gửi tới email của bạn.

Chúng tôi không thể gửi đường link đến email của bạn. Vui lòng kiểm tra lại địa chỉ email.

Hỗ trợ online


Sản phẩm:
Chương trình:
Ngôn ngữ:

Edit Borehole

The boreholes are edited in the "Edit borehole" dialog window. This window allows to change an edited borehole (in the left part of the dialog window) and also the master borehole (in the right part of the dialog window).

The tools of the dialog window are described on the example:

Dialog window "Edit borehole" - not compatible boreholes

In the left part of the dialog window, the data of edited borehole are displayed. The state of borehole (compatible/incompatible) is displayed above the borehole scheme. The aim of modification is to change a borehole into compatible and add it into the model.

In the right part of the dialog window, the data of master borehole are displayed.

In the middle part of the dialog window, the boreholes connection is shown. The height of boreholes is displayed correctly, so it is obvious which layers are horizontal. If the borehole (master or changed) are created from the test, the length of test is displayed in gray. On the picture, we can see, that the edited borehole was created from the test, which was not deep enough to achieve a yellow layers. On the other hand, the master borehole the upper layers are missing in its geological profile.

It is possible to use these buttons for borehole editing: ("Insert", "Add", "Edit", "Divide", "Merge", "Exchange", "Move interface" "Remove") for both tables. (If no row is selected in the table, only the "Add" button is available. After selecting a row, others buttons are displayed).

The borehole can be changed from incompatible to compatible by these steps:

- Edit selected borehole on the left part of the dialog window - Using an "Add" button for the , the layers "Gravel 2 " (yellow) and "Clay NG" (orange) are added. We can enter their assumed thickness, depth of interface or do not specify exact location.

Dialog window "Edit borehole" - modification of edited borehole

- Edit master borehole on the right part of the dialog window- Using an "Insert (before 1)" button (the first row in the master borehole table must be selected) for the master borehole in the right part of the dialog window, the Layers "Silt" (red) and "Sand 1" (blue). In this case the best way is not to specify exact location of the interface.

Dialog window "Edit borehole" - modification of master borehole

Because this way of modification is common and little bit lengthy (for bigger amount of layers), the program allows to perform this operations in a simpler way using the "Add upper layers" and "Add bottom layers" buttons in the upper part of the dialog window.

This way, the connection between boreholes is compatible.

Dialog window "Edit borehole" - compatible boreholes

The borehole type is also displayed in the dialog window - if the borehole is original (corresponds to the test profile) or changed. It is possible to return to the original borehole status using the "Copy from the soil profile" button.

Hãy tự trải nghiệm GEO5. Miễn phí, không có giới hạn khi phân tích