Đường link đã được gửi tới email của bạn.

Chúng tôi không thể gửi đường link đến email của bạn. Vui lòng kiểm tra lại địa chỉ email.

Hỗ trợ online

GEO5

Tree
Settings
Sản phẩm:
Chương trình:
Ngôn ngữ:

GB 50017-2003

The GB 50017-2003 standard adopts as the material parameter the steel design compressive, tension and bending strength f and shear strength fy. If this value is not determined for the used steel directly, it is back calculated from the steel yield stress fy as:

where:

γR

-

resistance sub coefficient, which is 1,087 for fy240 MPa and 1,111 for fy > 240 MPa

Check for bending with influence of normal force

The bending stress with influence of normal force is checked according to this expression:

where:

A

-

area of cross-section

W

-

elastic modulus of cross-section

γx

-

section plasticity develop factor

f

-

design strength of steel

Section plasticity develop factor γx depends on shape of cross-section. For I-sections, sheet piles and casing is considered as γx = 1,05. The value of utilization is provided by:

Check for shear

The shear stress τ is checked based on the following expression:

and the value of utilization is provided by:

State of plane stress verification

The state of plane stress is checked exploiting the following conditions:

where:

σ1

-

normal stress

τ1

-

shear stress in the verified section

β1

-

strength design value increase coefficient, which is 1,1

The value of utilization is provided by:

Hãy tự trải nghiệm GEO5. Miễn phí, không có giới hạn khi phân tích